Mipa 4+1 Acrylfiller HS has very good filling properties and is very easy to sand. This filler can be used as compact as well as high-build filler
Mipa 4+1 is also suitable to fill partial areas (Spot repair) without sinkage or visible marks in the outer rim
Easy to sand and gives perfect gloss hold out
Super high build, opacity and filling power
Fast drying
Use with H5 extra fast or H10 fast hardener
4-1 Mixing Ratio
German made
Technical Information
• Prime beforehand bare metal surfaces with a Mipa adhesion promoter (e.g. Mipa Rapidprimer, Mipa Aktivprimer or Mipa WBS 1K-Grundierfiller).
• Small iron and steel surfaces which are not larger than a hand can be directly recoated.
• In case of one-layer topcoat use sanding paper P 400 for dry sanding or P 600 for wet sanding. In case of a two-layer topcoat we recommend to use the sanding paper P 500/ 600 for dry sanding and P 800/ 1000 for wet sanding.
• Do not apply on thermoplastic substrates.
• The substrate must be clean, dry and free from grease. Sand surfaces slightly. Remove not cured old paintworks and priming coats.
 
Drying times
20 °C 3hr
10minutes Wet on Wet
60 °C - 20minutes
infrared drying shortwave - 8minutes
infrared drying mediumwave - 10-15minutes